Burkert ELEMENT 8222 - 6 Technical Data; Conditions of Use; Conformity to Standards and Directives; Conformity to the Pressure Equipment Directive

12
Technical data
6 TECHNICAL DATA
6.1 Conditions of use
Ambient temperature
–10...+60 °C
Air humidity
< 85%, without condensation
Use
Indoor and outdoor
▶ Protect the device against electromagnetic interference, ultravio-
let rays and, when installed outdoors, the effects of the climatic
conditions.
IP-Code
1) not evaluated by UL
IP67
1)
and IP65
1)
according to IEC / EN 60529
Mating connectors must be wired, plugged, and tightened.
Housing lid must be fully tightened and locked
Operating condition
Continuous operation
Equipment mobility
Fixed device
Degree of pollution
Degree 2 according to UL/EN 61010 -1
Installation category
Category I according to UL/EN 61010-1
Maximum height above sea level
2000 m
6.2 Conformity to standards and directives
The applied standards, which verify conformity with the EU directives, can be found on the EU-type examination
certificate and/or the EU declaration of conformity (if applicable).
6.2.1 Conformity to the Pressure Equipment Directive
▶ Make sure that the device materials are compatible with the fluid.
▶ Make sure that the pipe DN is adapted for the device.
▶ Observe the fluid nominal pressure (PN) for the device. The nominal pressure (PN) is given by the device
manufacturer.
The device conforms to Article 4, Paragraph 1 of the Pressure Equipment Directive 2014/68/EU under the fol-
lowing conditions:
• Device used on a piping (PS = maximum admissible pressure; DN = nominal diameter of the pipe)
Type of fluid Conditions
Fluid group 1, Article 4, Paragraph 1.c.i DN≤25
Fluid group 2, Article 4, Paragraph 1.c.i
DN≤32
or PSxDN≤1000 bar
Fluid group 1, Article 4, Paragraph 1.c.ii
DN≤25
or PSxDN≤2000 bar
Fluid group 2, Article 4, Paragraph 1.c.ii
DN≤200
or PS≤10 bar
or PSxDN≤5000 bar
English
Type 8222 ELEMENT