19
Assembly
7 ASSEMBLY
7.1 Safety instructions
Warning
Risk of injury due to non-conforming assembly.
▶ The device must only be assembled by qualified and skilled staff with the appropriate tools.
Risk of injury due to unintentional switch on of power supply or uncontrolled restart of the installation.
▶ Avoid unintentional activation of the installation.
▶ Guarantee a defined or controlled restart of the process subsequent to any intervention on the device.
7.2 Removing the housing lid
notice
The tightness of the device is not guaranteed when the housing lid is removed.
▶ Prevent the projection of liquid inside the housing.
The device may be damaged if a metal component comes into contact with the electronics.
▶ Prevent contact of the electronics with a metallic item.
2
→ [1] Turn the housing lid counterclockwise
with an angle of about 15° to unlock it.
→ [2] Remove the housing lid.
If the housing lid grips to the housing:
→ Use an appropriate tool to unlock the
housing lid, taking care not to scratch the
glass.
→ Insert an apropriate tool into the groove
of the housing.
→ Lever the housing lid up.
Fig. 6 : Removing the housing lid
English
Type 8222 ELEMENT
To Next Page
Loading...
