38
EN
15
16
9.1 Registration without a GSM
connection
If the registration via the GSM connection fails due
to lack of signal strength, this will be indicated by
unable to complete the registration even after trying
again, there are other alternatives for registering
your BWT product:
1. Use of an external GSM antenna. This can be
technician and is connected to the antenna
connection (16).
2. Integration of your BWT product into a home
network via LAN (RJ45 Ethernet connection
(15)) or WLAN.
9.2 LAN connection
LAN connection to the home network via an
existing router
Connect the LAN socket (15) of the BWT product
to the router of your home network using a network
cable (RJ45 Ethernet connection).
In the control panel of your BWT product, select
Info / Serial no. / PNR, scroll down and check the
DHCP item. The IP address assigned by the router
NOTE
Integration into a home network is pos-
sible using either LAN or WLAN. It is not
possible to have two connections at the
same time.
To enable data transfer, the follow-
ing port must be open on your router:
TLS / SSL port 443.
To Next Page
Loading...
