46
EN
10 Operator responsibilities
You have purchased a product that is durable and
easy to service. However, certain duties must be
carried out. Flawless function requires:
Operation as intended
Regular checks and servicing
Check the quality and pressure conditions of the
water quality changes, the settings may need to be
changed. Consult a specialist in this case.
To ensure the proper functioning and safety of
the product, regular inspections must be carried
out by the operator (every 2 months), and routine
maintenance (EN 806-5) must be performed by the
by BWT to carry out maintenance (every 6 months).
Wearing parts must also be replaced after the pre-
scribed intervals in order to guarantee functionality
10.1 Intended operation
The intended operation of the product includes
start-up, operation, decommissioning and, if nec-
essary, recommissioning. Intended operation of
the product and drinking water installation requires
regular checks, servicing and operation (water
operating conditions for design and construction,
including simulated sampling (manual or automated
rinsing), as appropriate. If simulated sampling is not
possible, the product must be taken out of service.
10.2 Checks
(Carried out by the operator)
BWT recommends that the operator regularly carry
out the following checks and record the results:
Water quality.
water values and set outlet water values may
need to be corrected.
Water pressure. If the pressure conditions
change, the product settings may also have to
be changed.
Operating condition of the product.
Check whether messages have been issued.
Watertightness.
To Next Page
Loading...
