5
EN
1.4 Transport and installation
To avoid damage during transport to the installation
location, do not remove the BWT product from the
packaging until you have reached the relevant lo-
cation. Then dispose of the packaging in the correct
manner. Check that the delivery is complete.
If there is a risk of frost, drain all components that
convey water.
Only lift or transport the product or product parts at
the eyebolts or attachment points provided.
The product must be placed on a horizontal surface
-
ing capacity. It must be secured so that it does not
fall or tip over.
1.5 Symbols used
This symbol indicates general
risks to persons, equipment or the
environment.
This symbol indicates risks due to
the mains voltage.
Risk of death by electric shock!
This symbol indicates information
or instructions that you must
observe in order to ensure safe
operation.
Unplug device before any service
and repair work.
This symbol indicates information
that is important to observe.
This symbol indicates that at the
end of its service life the electrical
or electronic device may not be
disposed of in household waste.
This symbol indicates that the
product can be recycled after it is
shut down.
To Next Page
Loading...
