48
EN
10.4 Maintenance in accordance with
EN 806-5
(Carried out by BWT after-sales service or
an authorised technician in accordance with
EN 806-5)
In addition to all inspection activities, maintenance
work on the assemblies listed below is required
every 6 months by BWT after-sales service or a
specialist trained by BWT. A detailed maintenance
BWT. We recommend that you enter into a mainte-
nance agreement with the BWT after-sales service
Assembly (the assemblies exist or do not exist
depending on the type and design of a BWT
product)
Cleaning and possible sanitisation
1.1 Entire hydraulic unit
1.2 End shield
1.3 Gears
1.4 Drive motor
1.5 Spool
1.6 Red/green injector
1.7 Electrolysis cell
1.8 Locking pin
1.9 Waste water elbow
2.0 JG hoses
2.1 Blending
2.2 Water meter cover
2.3 Impeller
2.4
2.5 Non-return valve
2.6 Bypass valve
2.7 Filler plug
3.1 Brine meter
3.2 Brine meter solenoid valve
5.1 Sieve base
5.2 Low salt gauge
5.3 Brine level switch
6.1
6.2 BWT AQA test
10.5 Replacement of parts
The operator must ensure that parts that are subject
to wear and ageing during the life of the product are
Details of the replacement cycles can be found in
the maintenance manual from BWT.
11 Warranty
If the product malfunctions during the warranty
period, please contact your contract partner, the
installation company, and indicate the model type
type plate on the unit).
Non-compliance with the installation conditions
and the responsibilities of the operator, as well
as improper use leads to the loss of warranty and
exclusion of liability.
11.1 Product returns
At BWT, product returns will not be processed
without a return number (RMA no.). In Germany,
call our after-sales service in Schriesheim to receive
a return number.
Unauthorised returns of goods will not be accept-
ed by BWT. Please always contact your contract
You can reach us at the following number:
Service acceptance +49 (0) 6203 / 7373
Monday to Thursday: 6:30 a.m. to 6:00 p.m.
Friday: 6:30 a.m. to 4:00 p.m.
To Next Page
Loading...
