EasyManua.ls Logo

BYD SEAL U DM-i - Precautions for Working Modes of Dual-Mode (DM) System

BYD SEAL U DM-i
260 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
CAUTION
The sand mode is recommended
for road with a thick gravel layer.
If the vehicle performance
decreases due to the activation
of dynamic stability control in
soft sand, snow/gravel/grassland
conditions, turning o󽗈 the ESC
system is conducive to improving
the vehicle performance. When
the di󽗋culty is overcome, the
ESC system must be restarted
Function.
Precautions for Working
Modes of Dual-Mode (DM)
System
When the vehicle operates in hybrid
synergy mode, pay attention to the
following:
The performance of the high-voltage
battery degrades in high- and low-
temperature environments. To prevent
the high-voltage battery from being
damaged, the following protection
mechanisms are set:
When the temperature is too high or
too low, the vehicle system limits the
charging and discharging power and
SOC level.
When the temperature is lower than
-30°C or higher than 60°C, the battery
cannot be charged.
When the temperature is lower than
-35°C or higher than 60°C, the battery
cannot discharge.
It is recommended to use the vehicle
in an environment above -20°C. In
the event of the above special
circumstances, it is recommended to
drive thevehicle by using the engine.
The optimum temperature of the
battery is 25°C. When the temperature
is too high or too low, the output
power of the battery is limited, so the
driving range of the vehicle in pure
electric mode is shortened.
Attention to High-voltage and
Hightemperature Components
The high-voltage battery and other
high-voltage components of the
vehicle are connected by orange
cables.
WARNING
Do not touch the orange cable
or the power battery electrode.
Electric shock may cause serious
or even life-threatening injuries.
Please read all warning labels.
The motor, coolant radiator, and some
other components may reach high
temperatures during driving. These
parts are attached warning labels.
Please carefully read and follow the
instructions on these warning labels.
WARNING
Do not remove or disassemble
any high-voltage parts, otherwise
serious or even life-threatening
injuries may be caused.
In the event of collision, 󽗊ooding,
and other situations that may
cause damage to the high-voltage
system, it is recommended to
contact a BYD authorized dealer
or service provider as soon as
possible for inspection to avoid
the risk of electric shock.
Do not continue to use the vehicle
to avoid the risk of electric
shock if the vehicle gives a
warning of electric leakage or a
39
01
SAFETY

Table of Contents

Related product manuals