EasyManua.ls Logo

BYD SEAL U DM-i - E-Call Switch; Passenger Airbag (PAB) Switch

BYD SEAL U DM-i
260 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
E-Call Switch
E-Call refers to emergency call. Press
down on the SOS button (duration:
1s≤t≤10s), and E-Call is triggered if this
button is not pressed again within 5
seconds after the initial press.
If users press the SOS button by
mistake, they can press the SOS button
again within 5 seconds to cancel the
call.
If an airbag deploys or a severe
collision is detected, E-Call is triggered
automatically.
Upon triggering, the E-Call system
automatically makes an emergency
call and reports the minimum set
of data (MSD) to a public safety
answering point (PSAP).
CAUTION
If the SOS button is pressed and
held for over 20 seconds, SOS
is deemed to have permanently
short-circuited (i.e. the button is
stuck). Under this circumstance,
E-Call cannot be triggered
manually.
E-Call cannot be canceled
manually after being triggered. It
remains active until PSAP hangs
up. If PSAP cannot establish
contact with the user after 10
consecutive attempts, the system
CAUTION
enters a waiting period of 60
minutes for a callback.
During the POST of E-Call system,
the indicator 󽗊ashes quickly at
2 Hz; when the E-Call system
works normally without any fault,
the indicator stays ON; during a
voice call triggered by the E-Call
system, the indicator 󽗊ashes at
1 Hz; when the voice call ends,
the indicator stays ON; when the
GPS signal is weak, the indicator
󽗊ashes slowly at 0.5 Hz, and
stays ON when the GPS signal
returns to normal; when the E-Call
system detects a serious fault, the
indicator remains OFF.
Passenger Airbag (PAB)
Switch*
The passenger airbag can be
deactivated if the car is equipped with
a passenger airbag switch.
The switch is located on the passenger
side of the dashboard and is accessible
when the passenger's door is open.
The front passenger airbag indicator is
located on the ceiling.
Check that the switch is in the required
position.
91
03
CONTROLLER OPERATION

Table of Contents

Related product manuals