CAUTION
(0℃) or when it is covered in snow
or frost may damage the sunroof
or its motor.
Initialization
With the vehicle powered on, when the
signal remains valid, and the sunroof
is not initialized, try the following
operations to initialize the settings:
1. Press and hold the sunroof closing
switch to make the sunroof move
to the fully closed position and stall
for 400ms, and then the sunroof
initialization is completed.
2.
After the sunroof has been initialized
and is fully closed, press and hold
the sunshade closing switch to make
the sunshade run to the fully closed
position and stall for 400ms, and
then the sunshade initialization is
completed.
CAUTION
●
During the whole initialization
process, press and hold the
sunroof/sunshade opening or
closing button until the sunroof/
sunshade is fully opened or
closed.
Interior Lights
Front/side interior lights
●
Front Interior Lights
●
Side Interior Lights
When the vehicle power is not OFF and
the "DOOR" switch is turned on, if this
switch is pressed with the door open,
the interior light switches from high to
low light, and does not go out. When the
vehicle is powered o and the "DOOR"
switch is turned on, the light goes out
after a period of time if the door is
opened. If there are other operations
during this period, the timer will be
restarted. (The user can slide down the
status bar on the top of the infotainment
touchscreen to open the Quick interface
and turn on or o the "DOOR" switch)
Ambient Lights*
To control the brightness, colour and area
of the ambient light, go to infotainment
touchscreen
→ Vehicle Settings →
Ambient Light.
90
To Next Page
Loading...
