BYD SEAL U DM-i - Function Definition

REMINDER
mold, which is very likely to
produce odours by long-term
fermentation.
●
How to prevent A/C odours:
●
Turn o󽗈 the A/C and ventilate
with natural air before parking
to keep the air inside the vehicle
relatively dry.
●
Inspect, clean, or replace the
󽗉lter regularly.
●
Try to keep the vehicle clean and
fresh.
●
If the odour persists after the
prevention measures are used,
it is recommended to contact a
BYD authorised dealer or service
provider for repair.
●
In order to keep the internal
working environment of A/C
system dry, the A/C blower may
automatically start for a while
after the vehicle is powered
o󽗈 and locked. It dries the
condensed water generated on
the evaporator surface when the
A/C is turned on, so as to
prevent mold breeding on the
evaporator surface. It is normal for
the A/C blower to start running
automatically when you lock the
vehicle. No need to worry about it.
Function De󽗉nition
Auto mode
●
Tap this button, and then the button
lights up (the automatic A/C button
indicator on the gearshift lever panel
lights up), and the compressor state,
blower speed, and vent mode are
automatically adjusted.
●
Features remain in the automatic
mode until other operation is
performed. If the blower speed, vent
mode or compressor state is manually
set, the full-automatic control is
disabled.
A/C ON/OFF
●
When the A/C is on, press this button to
turn the A/C o󽗈.
●
When the A/C is o󽗈, press this button
to turn the A/C on.
Seat vent/heating
●
Tap this button to enable the seat
ventilation and heating function.
See the P seats* in 3 - Operation
of Controller for speci󽗉c operation
methods.
Fan speed control
●
Tap this icon to set the blower speed to
the desired level. The higher the level,
the greater the blower speed.
Front windscreen defroster
●
Tap this button to enter the front
windscreen defrost mode, distributing
air to the front windscreen and side
windows. Tap this button again to exit
this mode.
●
Tap this button to turn on the
defroster, defogger, and A/C. That
is, the A/C is turned on regardless
of whether the compressor control
button is operated.
Temperature controls
●
Driver's temperature control
●
Individual Mode: Temperature
regulation on the driver side.
●
Relative Mode: Temperature
regulation on the driver and front
passenger side.
●
To increase/decrease the
temperature, tap the upper/lower
184