BYD SEAL U DM-i - Wiper Switch

CAUTION
●
The duration of lightening can
be changed by infotainment
interface.
Wiper Switch
●
The lever is used to control the
windscreen wipers and washer. It has
󽗉ve modes:
●
: Fast
●
: Slow
●
: Intermittent
●
: O󽗈
●
: Point-wiping
●
Push up or pull down the lever to
select a mode.
●
In slow and fast modes, the wiper
operates continuously.
●
To let wipers work in the spot-wiping
mode “
”, pull the lever from
the“ ” position. In this mode, the
front windscreen wipers operate at a
low speed until the lever is released.
Automatic wiper/Intermittent mode
●
The rain sensor automatically controls
the operation mode of wipers based on
the rainfall, and it is located in front
of the interior rearview mirror on the
front windscreen inside the vehicle.
●
To use the auto wiper function, turn
the wiper switch to the automatic
mode, go to infotainment touchscreen
→
→ Vehicle Settings → Greeting
and enable Auto wiper.
●
To use the intermittent wiper function,
turn the wiper switch to the automatic
mode, and disable auto wiper in
infotainment touchscreen
→
Vehicle Settings → Greeting.
●
The automatic wiper function has four
sensitivity levels. The higher the lever,
the higher the sensitivity. When using
the automatic wiper function, change
the sensitivity by adjusting the toggle
based on real-time rain conditions. If
the wiper reacts to rain too quickly,
reduce the sensitivity; if the wiper
reacts to rain too slowly, increase the
sensitivity.
Front windscreen washer
●
To clean the front windscreen, please
pull the wiper lever backward (towards
the steering wheel). In this case, the
washer sprays water all the time, and
the wiper works simultaneously.
●
If the lever is pulled for less than one
second, the wipers wipe once after the
current action. If the time exceeds one
second, the wipers wipe twice.
81
03
CONTROLLER OPERATION