CADD Legacy Plus 6500 - Changing to Lock Level 0 (LL0)

Section 2: Pump Setup and Programming
Pump Setup &
Programming
17
Changing to Lock Level 0 (LL0)
Before programming the pump, make sure the pump is set to LL0. LL0
allows the clinician to access all programming and operating functions.
1. Make sure the pump is stopped. Press
Œ
. e current lock level
will appear. (If the lock level is already LL0, press
„
to exit.)
2. Press
´
or
Î
until “LL0” appears.
3. Press
Œ
again or
¤
. “Code 0” will appear.
4. Press
´
or
Î
until ** Text Omitted **
WARNING: Do not disclose to the patient the pump’s security
codes or any other information that would allow the patient
complete access to all programming and operating functions.
Improper programming could result in death or serious injury
to the patient.
5. Press
Œ
or
¤
to set the new lock level.