CADD Legacy Plus 6500 - Electromagnetic Compatibility

64
Reference
Section 5: Reference
Electromagnetic Emissions and Immunity Declarations
Electromagnetic emissions declaration
The Pump is intended for use in the electromagnetic environment specied below. The
customer or the user of the Pump should assure that it is used in such an environment.
Emissions test Compliance Electromagnetic environment – guidance
RF emissions
CISPR 11
Group 1 The Pump uses RF energy only for its internal
function. Therefore, its RF emissions are very
low and are not likely to cause any interference
in nearby electronic equipment.
RF emissioins
CISPR 11
Class B The Pump is suitable for use in all establish-
ments, including domestic establishments and
those directly connected to the public low-
voltage power supply network that supplies
buildings used for domestic purposes.
Harmonic emissions
IEC 61000-3-2
Not applicable
Voltage uctuations/
icker emissions
IEC 61000-3-3
Not applicable
Compliance using:
1. 100VAC/50HZ to 8VDC Power Adapter (JPN) with a cord length of 274 ±
10 cm (108 ± 4 in).
2. 230VAC/50HZ to 8VDC Desktop Power Adapter (EU) with a cord length of
366 ± 20 cm (144 ± 8 in).
3. 115VAC/60HZ to 8VDC Power Adapter (US) with a cord length of 274 ±
10 cm (108 ± 4 in).
4. 230VAC/50HZ to 8VDC Desktop Power Adapter (UK) with a cord length of
366 ± 20 cm (144 ± 8 in).
5. 230VAC/50HZ to 8VDC Desktop Power Adapter (AUS) with a cord length of
366 ± 20 cm (144 ± 8 in).
6. 230VAC/50HZ to 8VDC Power Adapter (AUS) with a cord length of 274 ±
10 cm (108 ± 4 in).
7. 230VAC/50HZ to 8VDC Power Adapter (UK) with a cord length of 274 ±
10 cm (108 ± 4 in).
8. 230VAC/50HZ to 8VDC Power Adapter (EU) with a cord length of 274 ±
10 cm (108 ± 4 in).
WARNING: e use of Power Supplies other than those listed in
the Electromagnetic Emissions Declaration may result in increased
emissions or decreased immunity of the Pump.