Section 2: Pump Setup and Programming
Pump Setup &
Programming
22
Continuous Rate
Enter the continuous rate of medication delivery (in ml/hr). e maxi-
mum rate is 125 ml/hr.
Given
is screen shows the total amount of medication delivered since the last
time the value was cleared. e amount shown is rounded to the nearest
0.05 ml. If this value reaches 99999.95, it automatically returns to 0 and
continues counting. e Given amount does not include medication used
when priming the tubing.
Air Detector Status
is screen indicates whether the Air Detector is on high sensitivity, low
sensitivity or turned o. e Air Detector status cannot be changed with-
out entering the Biomed Functions Code (see Section 4, Biomed Functions,
to change the setting).
Upstream Sensor Status
is screen indicates whether the Upstream Occlusion Sensor is turned
on or turned o. e Upstream Sensor status cannot be changed without
entering the Biomed Functions Code (see Section 4, Biomed Functions, to
change the setting).
Before programming in Continuous Delivery Mode:
• Stop the pump and change the Lock Level to LL0 as described in Section 1.
• Select the Continuous Delivery Mode (CDM) as described in Chang-
ing the Delivery Methods in Section 4. If the pump is already in the
CDM, you may select it again to clear all programming screens to
their default settings.
To Next Page
Loading...
