CAE Aria - Setup Procedure

Setup
22 ©2021 CAE 905K690052 v1.0
CAEAria
Setup Preparation
To ensure that the manikin is ready for setup and prevent damage to your simulator, it is important
to complete the preparation steps as instructed.
Follow the guidelines below before you begin the setup procedure:
• Prior to using the manikin, ensure it reaches room temperature.
• Ensure multi-plug AC power outlets exist in the workspace to charge the simulator and its
powered components. The manikin and instructor tablet are battery operated and
enabled for wireless use.
• Plug in the tablet, manikin, and rechargeable accessories to a power source using only the
power cords provided. Use the diagram provided in the Unpacking Your CAE Manikin to
identify the designated cords associated with this equipment.
• Do not power on any components unless instructed to do so in the Setup Procedure
section of this guide.
Setup Procedure
After reviewing the guidelines for unpacking the manikin and setup preparation, proceed to the setup
procedure steps.
Set Up the Aria Simulator System
1
Place the Aria manikin in the work area.
2
Connect the manikin power cord to Aria.
3
Connect the manikin power cord to a power source.
4
Charge the Instructor Tablet.
5
Charge the Accessories.
6
Power on the Aria manikin.
7
Power on the Instructor Tablet.
8
Open the CAE Maestro software application on the Instructor tablet.
9
Modify the blood pressure cuff.
10
Prime the fluid systems.