Care and Maintenance
90 ©2021 CAE 905K690052 v1.0
CAEAria
Step 5: Flush and Drain the Urinary System
To flush and drain the urinary system:
1. Insert catheter in the urethra approximately 2.5 inches (6.35 cm) for the female genitalia
or 4.5 inches (11.43 cm) for the male genitalia.
2. Attach the urinary module assembly filling tool with clear distilled water.
3. Flush until clear water comes out of the catheter.
4. Fill tool with air and flush until no water can be seen entering the catheter.
5. Remove the catheter.
Step 6: Flush and Drain the Chest Tube
To flush the chest tube:
1. If red food coloring was used, rinse out the external bleeding tank.
2. Fill the tank with distilled water.
3. Insert the chest catheter in the chest tube haptic and place the catheter drain over a basin.
4. Run a chest tube SCE in the Masestro software or turn on the Flush command located on
the maintenance tab in the Maestro software.
5. Run until all clean distilled water is pushed through the circuit.
To drain the chest tube:
1. When the external bleed tank empties, air will be pushed through the circuit.
2. Allow air to pass, removing all fluid.
3. Stop the chest tube SCE simulation in the Maestro software or turn off the Flush
command located on the maintenance tab in the Maestro software.
Step 7: Flush and Drain the Bleeding System
Note: These instructions pertain only to an Aria manikin equipped with the bleeding system option.
To flush the bleeding system:
1. If red food coloring was used, rinse out the external bleeding tank.
2. Fill the tank with distilled water.
3. Connect the wound umbiical to the upper or lower bleeding port and place the hose end
into a basin.
To Next Page
Loading...
