©2021 CAE 905K690052 v1.0 31
Setup
Before catheterizing the simulator, the genitourinary (GU) system must be primed.
To prime the GU system:
1. Fill a syringe with distilled water (and clinically appropriate food coloring if desired).
2. Connect the syringe to the urinary module filling tool.
3. Plug the urinary module filling tool into the Urinary port.
4. Slowly inject a minimum of 4 mL of distilled water until fluid drains into the overflow
reservoir on the urinary module filling tool.
5. Disconnect the urinary module filling tool from the Urinary port.
6. Store the urinary module filling tool in a secure location.
Priming the Genitourinary System
To Next Page
Loading...
