Instruction Manual, November 2016 Page 17
The following keys are available:
DIALOG
Activates the manual parameter input mode (Method stack and
manual functions).
ARROW KEYS and
Select the next / previous parameter (or method) in the dialog.
If the “SYSTEM READY” display is active, pressing these keys will
display the actual temperature and humidity. By pressing another
key, these measurements will be cleared.
ENTER
Confirms the current parameter, switches to the selected dialog or
(re-)starts the (last) selected method in manual function.
END
Interrupts the current application or switches back to the previous
dialog.
If the “SYSTEM READY” display is active, you can enter the man-
ual function stack.
Select any manual function by arrow keys or .
Press ENTER, to start a manual function or DIALOG, if you
want to change the manual parameters.
• IQ-TEST (performs instrument’s functionality tests)
• HUMIDITY CTRL (performs a timed humidity process)
• DRYING (performs a drying step)
• RINSING (performs a rinsing step)
• LAST RESULTS (displays the results of the last run)
RESET
Resets and re-initializes the instrument. The current method is in-
terrupted but all parameters remain in memory.
RUN
Shows the selection of stored methods.
Use the arrow keys or to select a method to start.
Press ENTER to start the selected method or DIALOG to
change the parameters of the actual method.
To Next Page
Loading...
