CAMAG ADC 2 - Set LCD Contrast

ADC 2
Instruction Manual, November 2016 Page 30
7.2.2. Set display language
Start the setup dialog according to the procedure above. The dis-
play now shows the current baud rate.
 Press the ENTER key to move on to the language selection
display.
The current language setting is displayed.
 Press the  or  key to change the setting.
 Press the ENTER key to accept the current selection (and move
on to the LCD contrast selection).
 Press the RESET key to quit the setup dialog.
7.2.3. Set the LCD contrast
Start the user dialog according to the procedure above. The dis-
play now shows the current baud rate.
 Press the ENTER key twice to move on to the LCD contrast se-
lection display.
The current contrast setting is displayed.
 Press the  or  key to change the setting.
 Press the ENTER key to accept the current selection.
 Press the RESET key to restart the instrument.