Instruction Manual, November 2016 Page 29
CAMAG strongly recommends performing a preventive mainte-
nance depending on the usage, but latest after 12 Month. The
chapter Maintenance Data Sheet informs about the parts and
their frequency to be changed.
7.4. The Setup dialog
By means of the Setup dialog you can select the communication
baud rate between the instrument and the PC, the language and
LCD contrast.
To enter the Setup dialog:
Hold down the DIALOG key and press the RESET key.
Release the RESET key, then release the DIALOG key.
The display will now show ADC2 Vx.xx.xx Setup Mode, where
x.xx.xx is the actual firmware version of the ADC2.
Press the ENTER key to start the Setup dialog.
7.2.1. Set baud rate
Start the Setup dialog according to the procedure above. The dis-
play now shows the current baud rate (default is 57'600).
Press the arrow keys or key to change the setting.
Press the ENTER key to accept the current selection (and move
onto the language selection).
Press the RESET key to quit the user dialog.
To Next Page
Loading...
