0.4 01/2012 © CAME cancelli automatici s.p.a. - The data and information reported in this installation manual are susceptible to change at any time and without obligation on CAME cancelli automatici s.p.a. to notify users.
ENGLISH
- Release the gearmotor and position the bar vertically, and then refasten
the gearmotor.
- Hook the tie rod to the anchoring racket.
Perform the same procedure if there is a second screw.
- Insert the UNI5739
M12X70 screw into the
spring securing bracket and
tighten the UNI5588 M12
nut to the screw (1-2).
Tighten the screw to spring
(2) and the tie rod to the
part underneath (3-4).
To Next Page
Loading...
