Page
13 - Manual code:
FA00321-EN vers.
1 02/2017 © CAME S.p.A. - The data and information shown in this manual are to be considered subject to change at any time and without the need for any advance warning.
User menu
Info menu
Motor test menu
[Add User]
Enter up to a maximum of 250 users and associate each one with a function chosen from the available options. Use the transmitter or
another command device to do this (see ENTERING A NEW USER).
[Mod. name]
Change the number or the user name.
[Mod. Code]
Change the code for a command associated with a user.
[Related Func]
2-7
Open
2-3P
B1-B2
➡
Step-by-step command (open-close) or sequential command (open-stop-close-stop)
➡
Open command
➡
Pedestrian or partial command
➡
Output contact B1-B2
[Remove Usr]
Remove a user. Confirm with ENTER.
[Delete all Usr]
Delete all users. Confirm with ENTER.
[Backup data]
Save users and system settings in the memory roll. Confirm with ENTER.
[Restore backup]
Load the data saved in the memory roll onto the electronic circuit board.
If the boards have different versions, only the users can be loaded.
[Version]
View the software version.
[No. of Runs]
View the number of runs performed.
[Standby Msg]
View the initial standby message. To change the text, press ENTER. Use the ENTER key to move the cursor forward, ESC to move it
backwards and <> to select the letter or number. Confirm by pressing the ENTER key and holding for a few seconds.
[System Reset]
Restore to the original settings. Press the ENTER key to confirm.
[<= M1 M2=>]
Test to check the correct rotation direction of the gearmotors.
Press the < key and hold for a few seconds. Check that the M1 gate leaf opens. If the direction is wrong, invert the motor phases.
Press the > key and hold for a few seconds. Check that the M2 gate leaf opens. If the direction is wrong, invert the motor phases.
[USERS]
[TEST MOT]
[INFO]
To Next Page
Loading...
