Campbell CR6 - Page 156

Table 9-1: CR6 terminal commands
Command Description Use
0
Scan processing time; real
time in seconds
Lists technical data concerning program scans.
1
Serial FLASH data dump Campbell Scientific engineering tool
2
Read clock chip Lists binary data concerning the CR6 clock chip.
3
Status Lists the CR6 Status table.
4
Card status and compile
errors
Lists technical data concerning an installed memory
card.
5
Scan information Technical data regarding the CR6 scan.
6
Raw A/D values
Technical data regarding analog-to-digital
conversions.
7
VARS Lists Public table variables.
8
Suspend / start data output
Outputs all table data. This is not recommended as a
means to collect data, especially over comms. Data
are dumped as non-error checked ASCII.
9
Read inloc binary Lists binary form of Public table.
A
Operating system copyright
Lists copyright notice and version of operating
system.
B
Task sequencer op codes Technical data regarding the task sequencer.
C
Modify constant table
Edit constants defined with ConstTable /
EndConstTable. Only active when ConstTable /
EndConstTable in the active program.
D
MTdbg() task monitor Campbell Scientific engineering tool
E
Compile errors
Lists compile errors for the current program
download attempt.
F
Settings names Lists settings
G
CPU serial flash dump Campbell Scientific engineering tool
H
Terminal emulator menu Lists main menu.
I
Calibration data
Lists gains and offsets resulting from internal
calibration of analog measurement circuitry.
9. Tips and troubleshooting 138