MAINTENANCE PROCEDURES
219001750-010_a
1. Propeller shaft boot
Replace if damaged.
Wheel Bearing
Wheel Bearing Inspection
Lift and support vehicle. Refer to
LIFT-
ING AND SUPPORTING THE VEHI-
CLE
.
Push and pull the wheels from the up-
per edge to feel the play.
See an authorized Can-Am dealer, a re-
pair shop or person of your choosing if
thereisanexcessiveplay.
tmo2016-010-047_a
TYPICAL
Wheels and Tires
Wheel Removal
Loosen nuts then lift and support vehi-
cle. Refer to
LIFTING AND SUPPORT-
ING VEHICLE
.
Remove nuts then remove wheel.
Wheel Installation
Inspect studs and nuts. Replace if
needed.
The tires are unidirectional and the ir ro-
tation must be kept in a specific direc-
tion for proper operation.
Tighten w heel lug nuts in accordance
with the follo wing illustration.
TIGHTENING TORQUE
Wheel lug nuts
100N•m ±10N•m
(74lbf•ft ± 7lbf•ft)
tmo2016-010-048_a
TIGHTENING SEQUENCE
NOTICE
Always use the recom-
mended wheel nuts for the type of
wheel. Using a different nut could
cause damages to the rim or studs.
Tire Pressure
WARNING
Tire pressure greatly affects vehi-
cle handling and stability. Insuf-
ficientpressuremaycausetireto
deflate and rotate on wheel. Over-
pressure may burst the tire. Al-
ways follow recommended pres-
sure. NEVER set tire pressure be-
low minimum. It could cause the
tire to dislodge from the rim.
124
______________
To Next Page
Loading...
Need help?
General