EQUIPMENT
WARNING
Wear seat belts properly at all
times. Seat belts reduce the
risk of injury in a crash and help
keep limbs inside the cockpit in a
rollover or any accidents.
If driver's seat belt is not fastened
when:
– The ignition is turn ON, the seat belt
indicator lamp will flash .
– The engine is started and shift
lever is mov ed out of PARK, vehicle
speed will be limited to a maximum
of ap prox im ately 20 km/h (12 MP H)
on flat ground.
WARNING
The vehicle may reach higher or
lower speed depending on in-
clines.
Toremindyoutofastentheseatbelt,
the multifunction gauge will display the
following message: ENGINE LIMITA-
TION ENGAGED FASTEN SEAT BELT.
WARNING
There is no indicator light or mes-
sage for the passengers seat belts.
The driver is responsible for the
passengers safety and should en-
sure the passengers buckles their
seat belts.
Fastening and Adjusting the Seat
Belt
The seat belt is equipped with a semi-
cinching tab that lock the lap belt when
the webbing is under tension.
tmr2014-037-005_a
1. Semi-cinching tab
To fasten the seat belt, insert the latc h
plate into the buckle, then pull the belt
to ensure it is properly fastened.
Adjust the seat belt tightly against your
body by pulling the shoulder belt up-
wards.
219001761-210_a
TYPICAL
WARNING
Wear seat belt properly. Make sure
it remains securely fastened and
tightened against the body. Make
sure it is not twisted or defective.
To release the seat belt, push on the
redbuttonontheseatbeltbuckle.
10) Driver's Seat
On applicable models , The driver's
seatcanbeadjustedforwardandback-
ward.
_______________
73
To Next Page
Loading...
Need help?
General