BASIC PROCEDURES
Starting the Engine
Insert key in ignition switch and turn to
the ON position.
Press the brake pedal.
NOTE: If shift lever is not set to PARK
(P) or (N) NEUTRAL, the brake ped al
must be pressed to allow e ngine start-
ing.
Turn the ke y to the start position and
holduntiltheenginestarts.
NOTE: Do not press the accelera-
tor pedal. If the accelerator pedal is
pressed at least 50%, the engine will
not start.
Release the engine start position
immediately w hen the engine has
started.
NOTICE
If engine does not start
after a few seconds, do not hold the
start position more than 10 seconds.
Refer to
TROUBLESHOOTING
.
Operating the Shift Lever
Apply brakes and select the desired
shift lever position.
Release brakes.
NOTICE
When changing gear se-
lection, always completely stop the
vehicle and apply the brakes prior
to shifting. Damage to the gearbox
may occur.
Choosing the Correct
Range (Low or High)
It is important to limit situatio n s kno wn
to make the drive belt slip excessively.
The main reason the driv e belt will slip
is if the gearbox is in high range w hen it
should be in low range.
Pay attention to the following:
Low range
Low range should be used whenever:
– Pulling
– Pushing
– Hauling a load
– 4x4 applications
– Mud holes
– Water holes
– Crossing obstacles
– Climbing onto trailer
– Hill climbing
It is also recommended to use low
range if driving for prolonged periods
at speeds under 24 km/h (15 MPH)
Please refer to
BREAK-IN PERIOD
for
drive belt break-in information.
High range
High is the default riding range.
Electronic Drive Belt Protection
(if available and activated on your
model)
Some vehicles have the electron ic
drive belt pro te ction function acti-
vated.
Refer to your authorized Can-Am
dealer fo r availability an d possible acti-
vation.
This function is activated when riding
at too slow speed for the high range,
such as in the following situations:
– Pulling
– Pushing
– Hauling a load
– 4x4 applications
– Mud holes
– Water holes
– Crossing obstacles
– Climbing onto trailer
– Hill climbing
In the above mentioned situ atio ns th e
electronic drive belt protection will
help protect the CVT drive belt from
being dama ged by activating the en-
gine torque limiter. The gauge will also
scroll a
LOW GEAR
message, sug -
gesting the operator to immob ilize the
vehicle and set to LOW GEAR.
_______________
91
To Next Page
Loading...
Need help?
General