Name: Can-Am 2018 Defender Series
Brand: Can-Am
Rating: 5 (1 reviews)

To Next Page

To Previous Page

MAINTENANCE PROCEDURES

tmo2016-010-164_a

RH OF HEATING SYSTEM

1. Reta ining screw to remove

2. Heating system air inlet hose

3. Hea ting system air filter

Clean hea ting system a ir filters by tap-

ping ou t heavy dust, this will allow dirt

and dust out of the filters.

NOTICE

Do not blow compressed

air on the filters; this could damage

fibers and reduce filtration ability.

If filters are too dirty and cannot

be cleaned following the recom-

mended procedure, they should be

replaced.

128

______________

Foreword3
- Know before You Go3
- Safety Messages3
- About this Operator's Guide4
- Table of Contents5
- Safety Information11
General Precautions12
- Avoid Carbon Monoxide Poisoning12
- Avoid Gasoline Fires and Other Hazards12
- Avoid Burns from Hot Parts12
- Accessories and Modifications12
Safe Operation - Responsibilities13
- Owner - be Responsible13
- Operator - be Qualified and Responsible13
- Riding Carefully14
- Occupant Restraint System14
- Terrain Condition14
Pre-Ride Inspection16
- Pre-Ride Inspection Check List16
Prepare to Ride19
- Before You Ride19
- Riding Gear19
Avoid Accidents21
- Avoid Rollovers and Tipovers21
- Avoid Collisions22
Riding Your Vehicle23
- Practice Exercises23
- Off-Road Operation24
- General Riding Techniques24
Moving Loads and Doing Work29
- Working with Your Vehicle29
- Carrying Loads29
- Hauling a Load31
- Pulling a Trailer32
Important On-Product Labels33
- Hang Tag33
- Safety Labels36
- Technical Information Label46
- Compliance Labels47
- Vehicle Information49
PRIMARY CONTROLS (Cont'D)50
Primary Controls50
- Steering Wheel50
- Accelerator Pedal50
- Brake Pedal51
- Shift Lever51
Secondary Controls53
- Ignition Switch and Keys53
- Headlight Dimmer Switch55
- 2WD/4WD Switch55
- Rear Differential Switch (if Equipped)55
- Eco/Normal/Work Mode Switch (if Equipped)56
- Winch Switch (if Equipped)56
Multifunction Gauge (Lcd)57
- Multifunction Gauge Description57
- Multifunction Gauge Modes58
- Navigating in the LCD Gauge61
- Gauge Setup61
Multifunction Gauge (Analog/Digital)63
- Multifunction Gauge Features63
- Gauge Setup67
Equipment68
- Tilt Steering70
- Cup Holders70
- Passengers Handhold71
- Storage Compartments71
- Tool Kit74
- Footrests74
- Side Nets74
- Shoulder Guards74
- Seat Belts74
- Driver's Seat75
- Passenger Seats76
- Fuel Reservoir Cap76
- Winch (if Equipped)76
- Cargo Box77
- Cargo Box Tilt Release Handles77
- Anchoring Hooks77
- Tailgate77
- Trailer Hitch78
- 12-Volt Power Outlets78
- Full Doors with Electric Windows (Models with a Cab)79
- Full Glass Windshield with Wiper (Models with a Cab)79
- Rear Window with Sliding Opening (Models with a Cab)80
- Roof (if Equipped)80
- Heating System (if Equipped)80
Optional Equipment (if Available on Your Model)82
- Full Underbody Skid Plate82
- Gun Boot82
- Gun Boot Mount84
- Portable Light84
- Linq Tool Holders84
- LH Side Mirror86
- Half Windshield86
- Headache Rack87
- Central Panoramic Mirror87
Tune Your Ride88
- Suspension Adjustment Guidelines88
- Suspension Factory Settings88
- Suspension Adjustments88
- DPS Function89
Fuel90
- Fuel Requirements90
- Vehicle Fueling Procedure90
- Fueling a Gasoline Container91
Break-In Period92
- Operation During Break-In92
Basic Procedures93
- Starting the Engine93
- Operating the Shift Lever93
- Choosing the Correct Range (Low or High)93
- Stopping the Engine and Parking the Vehicle94
- Tips for Maximizing Drive Belt Durability94
Special Procedures95
- What to Do if Water Is Suspected to be in the CVT95
- What to Do if Battery Is Drained out95
- What to Do if Vehicle Rolled over95
- What to Do if Vehicle Is Submerged95
Transporting the Vehicle96
Lifting and Supporting the Vehicle97
- Front of Vehicle97
- Rear of Vehicle97
- Maintenance99
Maintenance Schedule100
- Severe Dusty Conditions100
- Maintenance Schedule Legend100
- Maintenance Schedule101
Maintenance Procedures104
- Engine Air Filter104
MAINTENANCE PROCEDURES (Cont'D)105
- CVT Air Filter105
- Evaporative Emission System Pre-Filter (if Equipped)106
- Engine Oil106
- Oil Filter108
- Radiator109
- Engine Coolant109
- Muffler and Spark Arrester112
- Gearbox Oil (HD8 and HD10)113
- Rear Final Drive Oil (HD5)114
- Differential Oil116
- Spark Plugs117
- CVT Cover118
- CVT Cover Installation (All Models)119
- Drive Belt119
- Battery122
- Fuses and Fusible Links122
- Lights124
- Drive Shaft Boot and Protector125
- Propeller Shaft Boot (HD5)125
- Wheel Bearing126
- Wheels and Tires126
- Suspensions127
- Brakes128
- Seat Belts129
- Doors with Electric Windows (if Equipped)129
- Heating System (if Equipped)129
Vehicle Care131
- Post-Operation Care131
- Vehicle Cleaning and Protection131
Storage and Preseason Preparation132
- Technical Information133
Vehicle Identification134
- Vehicle Identification Number134
- Engine Identification Number134
Evaporative Emission Control System135
Noise Emission Control System Regulation136
Ec-Declaration of Conformity137
Specifications138
- Troubleshooting149
Troubleshooting Guidelines150
Messages in Multifunction Gauge154
- Warranty155
Brp Limited Warranty Usa and Canada: 2018 Can-Am Ssv156
Us Epa Emission-Related Warranty160
California Evaporative Emissions Control Warranty163
Statement163
Brp International Limited Warranty: 2018 Can-Am Ssv165
Brp Limited Warranty for the European Economic Area, the Commonwealth of the Independant States and Turkey: 2018 Can-Am Ssv169
- Customer Information175
Privacy Information176
Contact Us177
- North America177
- Europe177
- Oceania177
- South America177
- Asia177
Change of Address/Ownership178

Questions and Answers:

Need help?

Do you have a question about the Can-Am 2018 Defender Series and is the answer not in the manual?

Can-Am 2018 Defender Series Specifications

General

Brand	Can-Am
Model	2018 Defender Series
Category	Automobile
Language	English

Can-Am 2018 Defender Series User Manual

Table of Contents

Questions and Answers:

Can-Am 2018 Defender Series Specifications