Canon EOS 650D - Page 228

228
Easy Wireless Flash Shooting
4
Select [Built-in flash settings].
 Select [Built-in flash settings], then
press <0>.
5
Select [EasyWireless].
 Under [Built-in flash], select
[EasyWireless], then press <0>.
6
Set [Channel].
 Set the transmission channel (1-4) to
the same one as the slave unit.
7
Take the picture.
 Set the camera and take picture in
the same way as with normal
shooting.
8
Exit the wireless flash shooting.
 For [Built-in flash], select
[NormalFiring].
 Setting [E-TTL II meter.] to [Evaluative] is recommended.
 Even though the firing of the built-in flash is disabled when
[EasyWireless] is set, it will still fire a small flash to control the slave unit.
Depending on shooting conditions, the flash fired to control the slave unit
may appear in the picture.
 Firing a test flash is not possible with the slave unit.
www.devicemanuals.eu
Set the transmission channel (1-4) to
www.devicemanuals.eu
Set the transmission channel (1-4) to
the same one as the slave unit.
www.devicemanuals.eu
the same one as the slave unit.
Take the picture.
www.devicemanuals.eu
Take the picture.
Set the camera and take picture in
www.devicemanuals.eu
Set the camera and take picture in
the same way as with normal
www.devicemanuals.eu
the same way as with normal
shooting.
www.devicemanuals.eu
shooting.
8
www.devicemanuals.eu
8
www.devicemanuals.eu