Preparing to Use the Machine as a Scanner
1560-02J
Make sure that the machine and your computer are connected and all software is installed. For how to check, see "MF
Driver Installation Guide." To connect via a wireless or wired LAN, you must register this machine in MF Network
Scanner Selector. Register by following the procedure below. This procedure is not required if the machine and your
computer are connected via USB.
The scan function is not available if the machine and your computer are connected in an IPv6 environment. Use
IPv4 or a USB connection.
1
Click in the system tray.
2
Select the check box for the machine, and click [OK].
● Up to ten computers can be connected at a time on a network to one product (scanner).
Using the Machine as a Scanner
128
To Next Page
Loading...
