Placing Documents
1560-00R
Place documents on the platen glass or in the feeder (MF244dw). Use the platen glass when scanning thick or bound
documents such as books. You can load two or more sheets of documents in the feeder so that they can be scanned
continuously. For information about the types of documents that can be placed on the platen glass or in the feeder,
and information about the scannable area of a document, see
Document Type(P. 417) or Scan Area(P. 418) .
Placing Documents on the Platen Glass(P. 38)
Placing Documents in the Feeder (MF244dw)(P. 39)
Use documents that are completely dry
When placing documents, make sure that any glue, ink, or correction uid on the documents has completely
dried.
To avoid paper jams (MF244dw)
Do not place the following types of documents in the feeder as this may cause paper jams:
● Wrinkled or creased paper
● Carbon paper or carbon-backed paper
● Curled or rolled paper
● Coated paper
● Torn paper
● Onion skin or thin paper
● Stapled or clipped documents
● Paper printed by a thermal transfer printer
● Transparencies
To scan documents more accurately (MF244dw)
Documents placed in the feeder are scanned while being fed into the machine. On the other hand, documents
placed on the platen glass remain in a xed position while they are scanned. To ensure more accurate scanning
results, placing documents on the platen glass is recommended.
To scan tracing paper or transparencies (MF244dw)
To scan transparent documents (for example, tracing paper or transparencies), place them on the platen glass.
Placing Documents on the Platen Glass
1
Open the feeder or the platen glass cover.
Basic Operations
38
To Next Page
Loading...
