Loading Envelopes
1560-00X
Make sure to atten any curls on envelopes before loading them. Also pay attention to the orientation of envelopes
and which side is face up.
Before Loading Envelopes(P. 49)
Loaded Orientation(P. 50)
This section describes how to load envelopes in the orientation you want, as well as procedures that you need
to complete before loading envelopes. For a description of the general procedure for loading envelopes in the
paper drawer or manual feed slot, see
Loading Paper in the Paper Drawer(P. 44) or Loading Paper in
the Manual Feed Slot(P. 47) .
Before Loading Envelopes
Follow the procedure below to prepare the envelopes before loading.
Only one envelope at a time can be loaded in the manual feed slot. Follow steps 1 to 4 in the procedure below
to prepare the envelope for loading.
1
Close the ap of each envelope.
2
Flatten them to release any remaining air, and make sure that the edges are pressed
tightly.
3
Loosen any stiff corners of the envelopes and atten any curls.
Basic Operations
49
To Next Page
Loading...
