2. Press the OK button.
The Set./Adj. Menu is displayed.
3. Press â–² or â–¼ to select System Setup, and then press the OK button.
4. Press â–² or â–¼ to select Output Method, and then press the OK button.
5. Press â–² or â–¼ to select Print, Print (Auto Del), or Save: Box 01.
Follow these steps only when you select Save: Box 01.
6. Press â–² or â–¼ to select the box, and then press the OK button.
Specify Print After Recv
To save print jobs on the hard disk before printing, specify Print After Recv.
Printing will start when Print After Recv is set to On, even if you have selected Save: Box 01 in Output Method.
1. On the Tab Selection screen of the Control Panel, press â—€ or â–¶ to select the Settings/Adj. tab ( ).
Note
• If the Tab Selection screen is not displayed, press the Menu button.
2. Press the OK button.
The Set./Adj. Menu is displayed.
3. Press â–² or â–¼ to select System Setup, and then press the OK button.
4. Press â–² or â–¼ to select Print After Recv, and then press the OK button.
5. Press â–² or â–¼ to select On or Off, and then press the OK button.
Print Jobs
>
Advanced Print Job Operations
>
Saving Print Jobs Sent from Sources Other than the Printer Driver iPF655
6
594
To Next Page
Loading...
Need help?
General