To Next Page

To Previous Page

Chapter 7

7-29

Caution point -2

Validate the settings (restart the printer)

The server address settings are activated only after you restart the printer. Make sure you always restart the printer after changing server address settings.

(1) How to enter Proxy server address

F-7-24

- Following symbols exist in each enter mode. (When you press the key, characters on the right hand side will appear.)

[a] Small alphabet letter mode: [Symbol] abcdefghijklmnopqrstuvwxyz

[A] Capital alphabet letter mode: [Symbol] ABCDEFGHIJKLMNOPQRSTUVWXYZ

[1] Numerical character mode: [Symbol] 1234567890

- [Symbol] appears in the following order.

F-7-25

- Within the URL entry field, you can use the or key to select a character, and the or key to move the cursor.

- The Stop key has the Delete function when there is a character at the cursor position. (The character at the position of the cursor is deleted, moving all following

characters one position toward freed place.)

If there is no character at the cursor position, it has the Backspace function. (The character at the left of the cursor is deleted, moving the cursor.)

- When you move the cursor to a position of a character and press the or key, you can insert characters.

(The character at the cursor position is moved to the right, and a new character is inserted.

- You can select the enter mode with the Navi key. (The default setting is small alphabet letter.)

(2) How to enter port number

F-7-26

- Possible to set between 1 and 65535 (The default display is 1).

- The top digit can be selected between 0 and 6. Other digits can be selected between 0 and 9.

- When OK key is pressed, and the value is over 65535, it is fixed on 65535.

- When OK key is pressed, and the value is 0, it is fixed on 1.

[1] Display to show enter mode

a: Small alphabet letter

A: Capital alphabet letter