Select whether B2 or 20 inch is applied when a roll of an intermediate size is detected.
â—¦ Roll paper setting 6â—¦
Select whether A1 or 600 mm is applied when a roll of an intermediate size is detected.
â—¦ Roll paper setting 7â—¦
Select whether 600 mm or 24 inch is applied when a sheet of an intermediate size is detected.
• Keep margin at cut sheet end•
When printing on the sheet using AirPrint, selecting Enable sets the trailing edge of the paper to 20 mm.
Select Enable if printing on the trailing edge of the paper is disturbed.
• Auto feed at power on•
When Enable is selected, the printer judges the existence of paper exchange when starting up, and if
paper has been exchanged, paper feeding operation is performed.
It may take time to judge paper exchange.
When Disable is selected, the printer does not judge whether or not to change the paper when starting
up, and waits with the current paper feed setting.
• Print advanced paper settings•
Prints out each setting specified in Advanced paper settings.
• Add priority roll paper width•
When paper size is detected, set the width of the roll paper to be recognized first. Judge in order from 1
in the list.
• Reset all detection priority data•
Resets estimated data for all learned paper when Auto detect or Auto with confirmation is selected in
Media type selection method.
• Reset paper settings for all paper•
Resets each setting in Advanced paper settings to its default value.
Entering the administrator password is required if it is enabled.
Important
• When you set the paper settings back to the factory default, added or updated paper information•
using Media Configuration Tool is erased.
358
To Next Page
Loading...
Need help?
General