Setting Item Description, Instructions
GL2
Set-
tings
Line &
Pen
Man-
ager
Pen
Setup
Select Palette Choose Software to print according to software set-
tings. Choose Palette A or Palette B to print using the
value specified in Define Palette.
Define Palette Specify the Width, Color, and Line Attributes in the
palette Pen no.. Choose Factory to confirm the values
when Factory is selected in Select Palette.
In Line Attributes, choose No Setting or Circle Set-
ting as the processing for the ends and junctions of
lines.
• If you choose No Setting
• If you choose Circle Setting
Reset Palette Restore Define Palette to the default palette settings.
Smoothing Choose whether to print arcs as smooth curved lines or
as multiple connected line segments.
• If you choose Software
Operation is determined by the application. If noth-
ing is specified by the application, the result is as
shown in the figure.
Note: By default, this is a 72-sided figure
• If you choose Smooth
ThickenFineLines Select On to print fine lines more distinctly.
Control Panel
>
Printer Menu
>
iPF755
Menu Settings
9
745
To Next Page
Loading...
