Canon LBP3360 - Page 267

8-30
Tr oubleshooting
8
Message List
<1H CHK TNR CONN.> (Warning Message)
Cause There is a possibility that the toner cartridge is not installed properly.
Remedy 1 Remove the toner cartridge, then reinstall it properly.
Remedy 2 If <1H CHK TNR CONN.> appears and there is a problem with the print quality
even after applying the Remedy 1, remove the toner cartridge and replace it
with a new one. (See "Replacing the Toner Cartridge," on p. 7-2)
<23 DOWN.MEM.FULL> <Auto Error Skip>
Cause The memory for registering macro and custom characters has run out and
overflowed.
Remedy 1 The printer continues printing by pressing the (Online) key. However, the
overflowed data cannot be registered.
Remedy 2 Perform a soft reset using the RESET menu, increase the free space of RAM
using the following procedure, register the data again, and then print again.
• Perform a hard reset or cycle the power of the printer (Be aware that all the
data in the memory will be deleted).
<26 SYS.MEM.FULL> <Auto Error Skip>
Cause The work memory required for the printer process has run out while the system
is processing the data (mainly the graphics data and text data).
Remedy 1 The printer continues printing by pressing the (Online) key. However, the
data with which an error has occurred is not printed properly.
Remedy 2 Perform a soft reset using the RESET menu, and then increase the free space
of RAM using the following procedure.
• Perform a hard reset or cycle the power of the printer (Be aware that all the
data in the memory will be deleted).
<27 JOB START ERR> <Auto Error Skip>
Cause The specified emulation does not exist.
Remedy Press the (Online) key to continue printing from the next data. However, the
data with which an error has occurred is not printed.