Canon LBP3360 - Page 268

8-31
Tr oubleshooting
8
Message List
<30 MEMORY FULL> <Auto Error Skip>
Cause The work memory has run out while the system is processing the data.
Remedy The printer continues printing by pressing the (Online) key. However, the
data with which an error has occurred may not be printed properly.
<32 2-SIDED ERROR> <Auto Error Skip>
Cause The printer received 2-sided printing data of paper sizes (including the
orientation) or paper types unavailable for automatic 2-sided printing.
Remedy 1 The printer continues printing by pressing the (Online) key. However, the
data on each side is printed on two pages.
Remedy 2 After performing a soft reset in the RESET menu, change the setting to a paper
size or type available for automatic 2-sided printing, and then print again.
<33 WORK MEM.FULL> <Auto Error Skip>
Cause The work memory for each operation mode cannot be secured.
Remedy 1 The printer continues printing by pressing the (Online) key. However, the
data with which an error has occurred is not printed properly.
IMPORTANT
When you continue printing by pressing the (Online) key , be aware that the data of
macro that is already registered may be deleted.
Remedy 2 Perform a soft reset in the RESET menu, increase the free space of RAM using
the following procedure, and then print again.
• Perform a hard reset or cycle the power of the printer (Be aware that all the
data in the memory that the printer has received will be deleted).
<35 TABLE FULL> <Auto Error Skip>
Cause The number of the documents in a job has exceeded 16.
Remedy The printer continues printing by pressing the (Online) key. However, the
job with which an error has occurred is not printed.
<38 LOW IMGE QLTY> <Auto Error Skip>
Cause The printer cannot process the data because it is too complicated.
Remedy 1 The printer continues printing by pressing the (Online) key. However, the
printer prints with the image quality level being lowered.