Canon LBP3360 - Page 273

8-36
Tr oubleshooting
8
Message List
<FM SCALE ERROR> <Auto Error Skip>
Cause There is a character in which the number of coordinate points on the contour
lines exceeds the limitation of a pseudo-scalable font.
Remedy Perform "Error Skip", then continue printing. However, the characters with which
an error has occurred are not printed properly.
<PC LOAD "size">
Cause The paper of the size specified in the application is not loaded in the paper
cassette or manual feed slot, or the paper source for the different paper size is
selected.
Remedy 1 Load the paper of the size selected in the application (or the one specified by
scaling factors). (See "Printing from the Paper Cassette," on p. 4-19)
Remedy 2 If you are using the manual feed slot, check SLOT PAPER SIZE, and when the
paper size does not match the size specified in the application, specify the
setting properly. (See "Printing from the Manual Feed Slot," on p. 4-37)
Remedy 3 Press the (Feeder Selection) key, then select the paper cassette in which the
paper of the matched size is loaded. (See "Selecting a Paper Source," on p.
4-12)
Remedy 4 Press the (Online) key, then print to the currently loaded paper forcibly. If
you are using the manual feed slot, the setting for SLOT PAPER SIZE
automatically changes to the setting specified in the application.
IMPORTANT
If you open the front cover when the message <PC LOAD "size"> is displayed, the
message may disappear. However, be sure to follow the directions in the displayed
message to change the paper.