Canon LBP3360 - Page 272

8-35
Tr oubleshooting
8
Message List
<D8 VERSION ERROR>
Cause You tried to print from a printer driver that is not for LBP3360.
Remedy Print from the printer driver for LBP3360.
<D8 SYNTAX ERROR>
Cause Invalid data is sent when printing using UFR II Printer Driver.
Remedy 1 Press the (Online) key to continue printing from the next data. However, the
page with which an error has occurred and its subsequent pages are not
printed.
Remedy 2 Confirm the data to be printed, then print again.
<D8 nn ERROR> ("nn" represents two-digit alphanumeric characters)
Cause A problem has occurred and the printer does not operate properly.
Remedy Cycle the power of the printer. If the message appears even after cycling the
power of the printer, note down the message in the display, and contact your
local authorized Canon dealer.
<F9-nn PWR OFF>ON> ("nn" represents two-digit alphanumeric characters)
Cause A problem has occurred while the printer is processing print data.
Remedy Cycle the power of the printer. If the message appears even after cycling the
power of the printer, note down the message in the display, and contact your
local authorized Canon dealer.
<FF FONT FULL> <Auto Error Skip>
Cause Because of too many fonts to be registered, the field (font table) for registering
font information has run out and overflowed.
Remedy The printer continues printing by pressing the (Online) key. However, the
page with which an error has occurred is not printed properly.
<FM SIZE ERROR> <Auto Error Skip>
Cause There is some font with its size exceeds the pseudo-scalable font size.
Remedy Perform "Error Skip", then continue printing. However, the characters with which
an error has occurred are not printed properly.