Canon NP6512 - Page 42

CHAPTER 2 BASIC OPERATION
COPYRIGHT © 1999 CANON INC. CANON NP6512/6612/7120/7130/7130F REV.0 AUG. 1999 PRINTED IN JAPAN (IMPRIME AU JAPON) 2-8
2. Inputs to the DC Controller (2/2)
Figure 2-106
When the light reflected by the original increases,
the voltage increases.
J107-4
-3
-2
-1
J111-15
J111-16
+24V
The variation in the resistance of the fixing heater
is corrected in three levels based on combinations
of 2-bit signals.
when toner level drops, ‘0’.
The keys and the LEDs are wired in a matrix
in the control panel PCB, and the DC controller
turns on or flashes the LEDs and reads key inputs.
AE
AEREF
PWOFF
SW309
Power switch
J111J301
DC controller PCB
DIG1
HEAT0
DIG1
HEAT1
J102-2
-3
-4
-5
J103
-1
J214-1
-2
-3
J215
-3
-2
-1
J952
J62
AE sensor PCB
Control panel
PCB
J601
+24V
TNMONI
Composite
power supply
PCB
+24V
J951-1
-2
J954
Toner
level
antenna
Toner level
detection
PCB