Cardinal 2240 - NET; TARE; TIME; DATE

KEY FUNCTIONS, Cont.
NET Pressing this key will toggle the weight display between the Net and Gross weight
GROSS display modes. NOTE: If a valid tare weight has not been entered, pressing this
key will toggle between Net and Gross modes (illuminating the appropriate
annunciator) with no change on the display.
TARE The TARE key is used to display the current tare weight (or zero if no tare has
been entered) and/or using the numeric keypad, to enter a new tare weight. It is
also used when entering a tare under a specific indentification (ID) number.
TIME Pressing this key will allow the entry of hours-minutes-seconds (6 digits) followed
DATE by the entry of the month-day-year (6 digits). NOTE: The time and date formats
are selected during setup of the counting scale.
lb/kg Pressing this key will toggle the weighing units between pounds (lb) and kilograms
(kg). NOTE: The currently selected weighing unit is indicated by illuminating either
the lb or kg annunciator (LED).
REMOTE Pressing this key while displaying any weight will select the optional external
SCALE scale (REMOTE) for sampling, counting or weighing operations. The Remote
Scale annunciator (LED) will illuminate to indicate the external (REMOTE) scale is
in use. NOTE: The REMOTE scale cannot be selected until it has first been
enabled in Setup and then calibrated.
ENTER The ENTER key is used to signal the completion of the data entry process and
starts the scale processing the data entered.
0 These keys are used to enter numeric data during setup and calibration as well
through as during normal operations. NOTE: The 1 and 0 keys have dual functions. They
9 are used to enter numeric data during setup and calibration as well as during
normal operations and are also used to answer Yes (1=YES) or No (0 = NO)
to various prompts.
This is the decimal point key used to enter a decimal point where required when
entering numeric data.
CE The CE key is used to perform different functions depending on the current mode of
operation:
Data Entry: The CE key is used to clear an incorrect entry from the display without
processing the data. If an incorrect entry is made, press the CE key and re-enter
the correct data. NOTE: The CE key must be pressed before the ENTER key to
ensure the data is not procesed.
Sample Mode (SAMPLE annunciator on): Pressing the CE key while in the Sample
mode during the initial Add display will reset the Add value to 5. This display
indicates the number of sample pieces to be added to (or removed from) the scale
platform.
NOTE: An invalid key entry will produce a long tone and no change on the
display.
9