Cardinal 2240 - Adjusting the Sample Quantity, Cont.; Counting Out From a Container; Accumulators

OPERATION USING ID(S), Cont.
Adjusting the Sample Quantity, Cont.
5. Press the SAMPLE key. Press the SAMPLE key again
to step to the next sample quantity. Note that pressing
the SAMPLE key repeatedly will cause the sample
quantity to step in the following sequence:
5, 10, 25, 50, 100, 5, 10, etc. OR
6. Using the numeric keypad, key-in any desired sample
value, then press the ENTER key.
7. Add or remove the indicated sample quantity and press
the COUNT or ENTER key.
8 Add or remove the pieces to be counted and read the
total count.
9. Press the ENTER key to complete the counting
operation and return to the Weight mode.
Counting Out From a Container
1. With the scale in the Weight mode (the Count display is
blank), press the ID key.
2. The ID annunciator will flash, the weight display will
show id=id=, and the count display will show the current
active ID.
3. If the current ID is to be used, press the ENTER key
OR if another ID is to be used, using the numeric
keypad, key-in the desired identification number and
press the ENTER key.
4. The ID annunciator will stop flashing and stay on, and
the scale will return to the Weight mode.
5. Place the filled container on the scale platform and
press the SAMPLE key.
6. Remove the number of pieces shown on the display and
press the COUNT or ENTER key.
7. Press the ZERO key to zero the count, then remove the
pieces from the container and read the total number
removed.
8. Press the ENTER key to complete the counting
operation and return to the Weight mode.
20
then
Add 5
SAMPLE
Add 10
SAMPLE
1 2 3 4 5
6 7 8 9 0
II0
0.000
lb
COUNT
0.000
lb
id= I524
ID
1 2 3 4 5
6 7 8 9 0
Add 5
SAMPLE
II0
COUNT
0
COUNT
0.000
lb