Cardinal 2240 - Counting With an Insufficient Sample; Adjusting the Sample Quantity

OPERATION USING ID(S), Cont.
Counting With an Insufficient Sample
1. With the counting scale on, unloaded, warmed up (on for
approximately 10 minutes), and in the Weight mode (the
Count display is blank), press the ID key.
2. The ID annunciator will flash and the weight display will
show id=id=, and the count display will show active ID.
3. If the current ID is to be used, press the ENTER key
OR if another ID is to be used, using the numeric
keypad, key-in the desired identification number and
press the ENTER key.
4. The ID annunciator will stop flashing and stay on, and
the scale will return to the Weight mode.
5. Press the SAMPLE key, then add the number of pieces
indicated on the display and press the COUNT or
ENTER key.
6. If the sample weight is too small, the INSUFFICIENT
SAMPLE annunciator will flash and the display will show
the number of additional pieces to be added.
7. Add or remove the pieces requested, then press the
COUNT or ENTER key or if Manual Count Override* is
enabled, press the COUNT or ENTER key to force a
count function. If the pieces are not added or removed,
the INSUFFICIENT SAMPLE annunciator will continue
to flash to show the out-of-tolerance count.
NOTE: If the Manual Count Override is not enabled
and less than the displayed number of pieces are
added or removed when requested to add additional
pieces, the counting operation will terminate and the
scale will return to the Weight mode.
8 Add or remove the pieces to be counted and read the
count.
9. Press the ENTER key to complete the counting
operation and return to the Weight mode.
* Refer to Calibration and Setup section
Adjusting the Sample Quantity
1. With the scale in the Weight mode (the Count display is
blank), press the ID key.
2. The ID annunciator will flash, the weight display will
show id=id=, and the count display will show the current
active ID.
3. If the current ID is to be used, press the ENTER key
OR if another ID is to be used, using the numeric
keypad, key-in the desired identification number and
press the ENTER key.
4. The ID annunciator will stop flashing and stay on, and
the scale will return to the Weight mode.
19
or
1 2 3 4 5
6 7 8 9 0
Add 5
5
II0
0.000
lb
id= I524
ID
Add 25
INSUFFICIENT
SAMPLE
SAMPLE
30
COUNT
INSUFFICIENT
SAMPLE
COUNT
0.000
lb
0.000
lb
id= I524
ID
1 2 3 4 5
6 7 8 9 0
0.000
ID