OPERATION USING ID(S), Cont.
Accumulators
Displaying the Accumulator for the Active ID.
1. With scale in the Weight mode (the Count display is
blank), press the ID key.
2. The ID annunciator will flash, the weight display will show
id=id=, and the count display will show the current active ID.
Press the ENTER key.
3. The ID annunciator will stop flashing and stay on, and the
scale will return to the Weight mode.
4. Press the ACCUM key to display the contents of the
accumulator. The ACCUM annunicator will illuminate.
5. Press the ACCUM key to return to the Weight mode.
Clearing the Accumulator for the Active ID.
1. With scale in Weight mode (the Count display is blank),
press the ID key.
2. The ID annunciator will flash, the weight display will
show id=id=, and the count display will show the current
active ID. Press the ENTER key.
3. The ID annunciator will stop flashing and stay on, and
the scale will return to the Weight mode.
4. Press the ACCUM key (illuminating the ACCUM
annunicator) to display the contents of the accumulator
for the ID entered.
5. Press the ZERO key to reset the accumulator to zero.
6. Press the ACCUM key to return to the Weight mode.
Displaying the Accumulator for a Non-Active ID.
NOTE: The following steps change the Non-Actve ID to
the Active ID to Display the Accumulator.
1. With scale in the Weight mode (the Count display is
blank), press the ID key.
2. The ID annunciator will flash, the weight display will
show id=id=, and the count display will show the current
active ID.
3. Using the numeric keypad, key-in the desired
identification number and press the ID key.
4. The ID annunciator will stop flashing and stay on, and
the scale will return to the Weight mode.
5. Press the ACCUM key to display the contents of the
accumulator. The ACCUM annunicator will illuminate.
6. Press the ACCUM key to return to the Weight mode.
21
0.000
2583I
ACCUM
id= I524
ID
0.000
ID
id= I524
ID
2583I
ACCUM
0
ACCUM
0.000
lb
id= 1524
1 2 3 4 5
6 7 8 9 0
ID
2583I
ACCUM
ID
ID
To Next Page
Loading...
