OPERATION USING ID(S), Cont.
Adding ID Numbers
NOTE: If a stored tare weight is desired for an ID, it is recommended to select
the scale (Local or Remote) and place the empty container to be used for the
tare on the appropriate scale before pressing the ID key in step 1.
1. With the counting scale on, and in the Weight mode
(the Count display is blank), press the ID key.
2. The ID annunciator will flash and the weight display will
show id=id=. NOTE: If this is the first ID to be added, the
count display will be blank, otherwise the current active
ID number will be shown in the count display.
3. Key-in up to a 12 digit identification number and press
the ID key. Note, that when entering an ID number, the
digits start displaying on the left side of the count
display and proceed to the right. When an ID greater
than 6 digits is used, the digits will automatically scroll
off the left side of the count display to show the
additional digits on the right as they are entered.
4. The display will change to TARE=TARE= and show the current
tare weight (the weight of the empty container). Press
the ENTER key if the current scale weight is to be used
for the tare or using the numeric keypad, key-in the tare
and press the ENTER key. Note, entering a 0 (zero) for
tare and pressing the ENTER key will select no tare.
5. The display will change to UNITSUNITS. If the Average Piece
Weight is known, use the numeric keypad to key-in the
value and press the ENTER key OR if the average
piece weight isn't known press the ENTER key.
6. The display will change to ACCU=ACCU= and show the current
value of the accumulator associated with the ID number.
If the displayed value is to remain unchanged, press the
ENTER key OR using the numeric keypad, key-in the
desired accumulator value and press the ENTER key.
7. The ID annunciator will stop flashing and stay on,
indicating the ID has been stored and is now the current
active ID. Counts will accumulate from this point.
8. Repeat the above steps for all ID numbers to be added.
When completed, proceed to the "Standard Sampling
and Counting" section of this manual.
Deleting ID Numbers
1. With the counting scale on, and in the Weight mode
(the Count display is blank), press the ID key.
2. The ID annunciator will flash, the weight display will
show id=id=, and the count display will show the current
active ID.
NOTE: If 7 to 12 digit ID numbers have been used, press the "-" (minus) key to
scroll the number displayed to the right and the "+" (plus) key to scroll the
number displayed to the left to view the complete ID number.
16
0.000
lb
id=
I524
1 2 3 4 5
6 7 8 9 0
tArE=
0.000
ID
Accu= 0
unitS 0.000
0.000
ID
id=
I524
0.000
ID
To Next Page
Loading...
