Cardinal 2240 - Adjusting the Sample Quantity; Counting Out From a Container; Accumulator

OPERATION WITHOUT ID, Cont.
Adjusting the Sample Quantity
1. Press the SAMPLE key. Press the SAMPLE key again
to step to the next sample quantity.
Note, pressing the SAMPLE key repeatedly will cause
sample quantity to step in the following sequence: 5, 10,
25, 50, 100, 5, 10, etc. OR
3. Using the numeric keypad, key-in any desired sample
value, then press the COUNT or ENTER key.
4. Add or remove indicated sample quantity and press the
COUNT or ENTER key.
5. Add or remove the pieces to be counted and read total
the count.
6. Press the ENTER key to complete the counting
operation and return to the Weight mode.
Counting Out From a Container
1. Place the filled container on the scale platform and
press the SAMPLE key.
2. Remove the number of pieces shown on the display and
press the COUNT or ENTER key.
3. Press the ZERO key to zero the count, then remove the
pieces from the container and read the total number
removed.
4. Press the ENTER key to complete the counting
operation and return to the Weight mode.
Accumulator
Displaying the Accumulator.
With scale in the Weight mode (Count display is blank)
or in the Count mode (COUNT annunciator ON), press
the ACCUM key (ACCUM annunicator illuminates) to
display the contents of the accumulator. Press the
ACCUM key again to return to the previous display or
press the SAMPLE key to go to the sample display.
Clearing the Accumulator.
With scale in the Weight mode (Count display is blank)
or in the Count mode (COUNT annunciator ON), press
the ACCUM key (illuminating the ACCUM annunicator)
to display the contents of the internal accumulator.
Press the ZERO key to reset the accumulator to zero,
then press the ACCUM key to return to the previous
display.
13
then
Add 5
Add I0
0.000
Add 5
II0
0.000
0.000
lb
COUNT
SAMPLE
II0
COUNT
lb
lb
0
ACCUM
1 2 3 4 5
6 7 8 9 0
SAMPLE
SAMPLE
0
COUNT
0.000
lb
2583I
ACCUM
ACCUM
25831