INSTALLATION
Unpacking
Before beginning installation of your Digital Counting Scale, make certain the instrument has
been received in good condition. Carefully remove the instrument from the shipping carton and
inspect it for any evidence of damage (such as exterior dents or scratches) that may have taken
place during shipment. Keep the carton and packing material for return shipment if it should
become necessary. It is the responsibility of the purchaser to file all claims for any damages or
loss incurred during transit. Refer to the Counting Scale Unpacking and Re-Packing
Instructions, 8526-M246-01, for additional information.
Placement
Place the scale on a stable, vibration-free level surface away from direct sunlight and from any
rapidly moving air source (heating/cooling vents, fans, etc.). Make certain the power cord and
peripheral cables are routed out of the way of normal traffic.
CAUTION! DO NOT place the scale on any unstable cart, stand or table. The
scale may fall causing injury to the operator, and seriously damage the unit,
or proper operation of the scale may be inhibited.
Level Adjustment
Check to make certain the scale is level. The level indicator is located in the center of the
weighbridge under the Stainless Steel commodity tray. Remove the commodity tray and
observe the level bubble (see Figure No. 1). If the scale is not level (the bubble will not be
centered), loosen the locking nut on all four (4) mounting feet (see Figure No. 2) and adjust
them as required to center the bubble and attain a level scale. Once a level condition has
been obtained, lock the mounting feet in place by tightening the adjustment nuts against the
bottom of the scale.
Figure No. 1
Power Connection
The scale contains a power supply which converts the 110/120/220/240 VAC 50/60Hz wall
supply to the power required by the scale circuitry. The power supply also contains the circuitry
necessary to monitor and recharge the optional battery and is capable of operating the scale and
recharging the battery simultaneously.
3
Leveled
Not Leveled
To Next Page
Loading...
