Cardinal 2240 - Operation Without ID; Standard Sampling and Counting; Automatic Average Piece Weight Re-Computation; Counting With an Insufficient Sample

OPERATION WITHOUT ID
Standard Sampling and Counting
1. With the scale on and warmed up (on for approximately
10 minutes) and in the Weight mode (Count display is
blank) press the SAMPLE key.
2. Add the number of pieces indicated on the count display
and press the COUNT or ENTER key.
3. Add the pieces to be counted and read the total count.
4. Press the ENTER key to complete the counting
operation and return to the Weight mode.
Automatic Average Piece Weight Re-Computation
Immediately after a standard sampling operation, if a quantity of pieces, less than the original
sample size is added to the scale platform, a new average piece weight will be calculated
automatically. This new average piece weight is based on a larger sample than that used initially
therefore improving the accuracy of the count.
NOTE: The automatic recomputation of the average piece weight occurs only once for each new
sample. Note also that the recalculation of the average piece weight will not take place if the
quantity of pieces added is equal to or greater than the original sample quantity, nor will it take
place if the display mode is changed before the pieces are added.
Counting With an Insufficient Sample
1. With the scale on and warmed up (on for approximately
10 minutes) and in the Weight mode (Count display is
blank) press the SAMPLE key.
2. Add (or remove) the number of pieces indicated on the
count display and press the COUNT or ENTER key.
3. If the sample weight is too small, the INSUFFICIENT
SAMPLE annunciator will flash and the display will show
the number of pieces to be added or removed.
4. Add or remove the number of pieces requested and
press the COUNT or ENTER key or if Manual Count
Override* is enabled, press the COUNT key to force a
count function. Note that if the pieces are not added or
removed, the INSUFFICIENT SAMPLE annunciator will
continue to flash to show the out-of-tolerance count.
NOTE: If the Manual Count Override is not enabled
and less than the displayed number of pieces are
added or removed when requested to add additional
pieces, the counting operation will terminate and the
scale will return to the weight display.
5. Add or remove the pieces to be counted and read the
count.
6. Press the ENTER key to complete the counting
operation and return to the Weight mode.
* Refer to Calibration and Setup section
12
or
5
I I 0
Add 5
Add 25
Add 5
INSUFFICIENT
SAMPLE
30
INSUFFICIENT
SAMPLE
ll0
5
0.000
lb
0.000
lb
SAMPLE
COUNT
COUNT
SAMPLE
COUNT
COUNT