OPTIONAL BATTERY PACK OPERATION
The Digital Counting Scale can operate from a readily available Sealed Lead-Acid Camcorder
type battery (not included). If you wish to operate the scale from a battery, you must first obtain
and install a CAM-350 Type 12 volt 2000 mAh (2.0 Ah) battery before operations can begin. The
battery is contained inside the instrument and is easy to install. Access is via a removable panel
on the right side of the scale (See Figure No. 11). The scale will operate with a "fully charged"
battery for approximately ten (10) hours and is easily recharged with the scale's built-in charger.
NOTE: The battery can be purchased from the Cardinal Scale Parts Department
(p/n 6800-0018) or ordered from the following companies online:
www. planetbattery.com www.ebatts.com
www.discountcell.com www.mobilizenow.com
Installation
1. Unplug the AC power cord from the back of the scale.
2. Loosen the retaining thumbscrew securing the Battery Access Cover to the side of the scale
and position the cover towards the rear of the scale, exposing the battery access opening.
3. Make certain the ( + ) plus polarity markings of the battery pack are positioned up (toward the
platter).
4. While holding the cover open, slide the battery into the opening until you feel resistance and
the battery in almost flush with the side panel of the scale (See Figure No. 11).
5. Close the Battery Access Cover and finger-tighten the thumbscrew, securing the battery in
place.
Figure No. 11
Battery Pack Removal
1. Unplug the AC power cord from the back of the scale.
2. Loosen the retaining thumbscrew securing the Battery Access Cover to the side of the scale
and position the cover towards the rear of the scale, exposing the battery access opening.
3. An internal spring will push the battery partially out of the opening. Grasp the end of the
battery and slide it out of the opening.
4. Close the Battery Access Cover and finger-tighten the thumbscrew.
34
Battery Access Opening
Thumbscrew
To Next Page
Loading...
