Nov-21 Page 20 of 132 59812-K001 Rev 10
On when power is applied to the system.
Indicates a fault on the system
Indicates there is a fault on a detector
Indicates a failure to communicate with one or more detector
Indicates a fault with the Control Panel or a Control Panel
Software failure.
Indicates there is an isolation on the system.
Indicates one or more detectors is isolated.
Indicates all of the detectors on one or more engines are all
isolated.
Indicates one or more shutdown relays are isolated.
Indicates there is an alarm on that engine
Indicates fault on that engine
Indicates there is an isolation on that engine
The Control Panel is menu driven and provides a logical route to all functions. It has three operating
levels:
User
Engineer
Service
The User level is essentially for read only interrogation and does not allow any adjustments to be made
to alarm settings or system configuration.
The Engineer level is password protected and allows access to most functions and the full range of
programmable settings.
When selected, a prompt for a password will appear, enter 012345, when programming is completed, if
required, the Password may be changed by an authorised person to prevent unauthorised access in the
future. This process can be followed in section 2.8 of this manual.
The Service level is also password protected (different from the Engineer Menu) and allows access to
all functions. This is only available to authorised Carrier personnel and authorised Service Providers.
To Next Page
Loading...
